Indesit IDL 600 Manual page 21

The filters remove food residue from the water used in
the wash cycle: to obtain the best results from each
wash, they should be cleaned.
 Clean the filters regularly.
 After cleaning check that the filter assembly has
been replaced correctly.
 The dishwasher should not be used without filters.
1. Remove the filters by pulling the handle upwards.
2. Clean the filters:
C
1
2
A
B
• The entire filter assembly should be cleaned
C
B
A
3. Reconstruct the filter assembly and replace it in the
correct position, following movements 1 and 2 as
shown in the figure, until it clicks into place.
• Run a wash cycle when the dishwasher is empty.
• Unplug the appliance and disconnect the water
supply.
• Leave the door of the appliance ajar.
• after every wash
cycle, remove the
largest pieces of residue
from semicircular plate
A and glass B (these
may be removed by
pulling the handle) by
rinsing them under
running water.
thoroughly once a
month: this includes the
semicircular plate A, the
glass B and the cylinder
C (this may be removed
by turning it in an anti-
clockwise direction).
Use a small non-metallic
brush to clean these
parts.