Programming A Recording With The Recording & Playback Navigator; To Change Or Cancel The Program - Emerson EWH100F Owner's Manual

Recording & Playback Navigator (Cont'd)
Programming a Recording with
the Recording & Playback
Navigator
DVR DVR
Before programming, be sure to select the desired Rec
Mode. (See page 36 on how to select the Rec Mode.)
1
Press PROGRAM RECORDINGS.
Switches to the DVR mode, and the Programmed
Recordings Screen will appear.
2
Using / / /
• For example, to record from 4:00 pm two days
from the present day, choose the cell as follows.
ordings
THU FRI TODAY SUN MON TUE WED THU FRI
PM
3
4
5
Present day
Tomorrow
There are two ways to program a recording.
1) Direct Program---Press CHANNEL
the Number Buttons to select a channel. Press
ENTER.The cell turns pink indicating that the
timer programming is now set in that cell.
Press PROGRAM RECORDINGS to exit.
2) Detailed Program---Press ENTER
"New Program" will appear.With "New
Program" selected, press ENTER again.
Timer Programming Window will appear.
Date Start Time
Fri FEB/ 3 9 : 00 AM
Enter the necessary information by following the
instructions described in 'Timer Recording' on pages
40-43.
Recording / Dubbing
, select the desired cell.
Scheduled Recordings
SAT
Cell
Day after tomorrow
/
End Time CH Rec To
10 : 00 AM 8 DVR
DVR LP
To Change or Cancel the
Program
DVR DVR
1
Repeat steps 1-2 above.
2
Press ENTER to call up the menu window.
3
To change the program
Using /
press ENTER.
Timer Programming Window will appear.
Correct the information, then press ENTER.
To cancel the program
Using /
press ENTER.
Timer Programming List will appear.
Press CLEAR .
Confirmation window will appear. Select "Yes", and
or
press ENTER.
To program a new Timer Recording
Using /
press ENTER.
4
Press TIMER PROG. to exit.
Mode
LP
0:39
Program Change
Display
Timer Program
New Program
, select "Program Change", then
, select "Timer Program", then
, select "New Program", then
45