Replace the 3 1/2-inch device bracket in the 3 1/2-inch
3.
device slot. Take care to prevent pulling and loosening
cable connections.
Secure the device bracket in place with the four screws
you removed earlier.
Securing the desktop 3 1/2-inch drive bracket
If you installed a 1.2-MB diskette drive, remove the
4.
protective cardboard insert from the drive.
Replace the system unit cover (see Chapter 5).
5.
Be sure that you do not pinch any cables or wires when
you replace the cover.
Connect external peripherals and power cables.
6.
Run the Setup program to set your new configuration
7.
(see Chapter 2, Setting System Parameters).
Adding Options 6-53