NEC MH110 - SETUP AND Administration Manual page 59

Messages
No Net Access
No Net Found
No Reg Domain
Not Installed!
Press End Call
Restart
Command
Select License The correct protocol has not
been selected from the license
set.
Server Busy
SVP Service Rej.
System Locked
(with Busy Tone)
System Busy
(with Busy Tone)
MH110/MH120 IP Wireless Telephone Setup and Administration Guide - Revision 1
Descriptions
Cannot authenticate / associate with
AP
This indicates any of the following:
No radio link
No ESSID – Autolearn not supported
(or)
incorrect ESSID
Out of range
Incorrect WEP settings
Regulatory Domain not set.
A required software component is
missing.
If your call has ended.
The Mobile Handset received a
restart command from the supported
NEC VoIP solution.
Mobile Handset is attempting to
download from a TFTP Server that is
busy downloading other devices and
refusing additional downloads.
The SVP Server has rejected a
request from the Mobile Handset.
SVP Server is locked.
SVP Server is busy or out of
resources.
Troubleshooting Mobile Handset Problems
Actions
Verify the AP configuration.
Verify that the AP is turned on.
Verify the ESSID of the wireless LAN and enter or Autolearn it
again if required.
Try getting closer to an AP. Check to see if other Mobile Handsets
are working within the same range of an AP. If so, check the
ESSID of this Mobile Handset.
Verify that all the WEP settings in the Mobile Handset match those
in the APs.
Configure the Regulatory Domain of the Mobile Handset
Check that all required software files are on the TFTP server, if
over-the-air downloading is being used. If the error repeats,
contact NEC Technical Support.
Press the Power Off / End Call key
to return to standby mode.
None. The Mobile Handset will automatically
restart in a few seconds.
Using the administrative menus, select one license
from the set to allow the phone to download the
appropriate software.
None, the Mobile Handset will automatically retry the download
every few seconds.
The Mobile Handset will restart and attempt to re-register with the
SVP Server, which should fix the problem. Report to your
administrator if it keeps happening.
Try call again later, system has been locked for maintenance.
All call paths are in use, try call again in a few minutes.
11-5