Mobile Handset Configuration; Opening The Admin Menu - NEC MH110 - SETUP AND Administration Manual

4

Mobile Handset Configuration

Chapter Topics
The Admin Menu
NOTE
MH110/MH120 IP Wireless Telephone Setup and Administration Guide - Revision 1
The MH110/MH120 UNIVERGE WL Mobile Handsets (Mobile Handsets)
should be provisioned in the supported NEC VoIP solution in the same
manner as the NEC DtermIP-16LDs. Each Mobile Handset may be
configured for site-specific requirements by opening the Admin menu
and selecting options or entering specific information. Any settings
entered in the Admin menu must conform to system settings. Only the
Mobile Handset being configured is affected by the Admin menu
settings.
The Mobile Handset user may select several usability options from the
Standby menu, described in the
10. This information is also provided in the end user manual.
• The Admin Menu
• User-defined Preferences
The Admin Menu contains configuration options that are stored locally
(on each Mobile Handset). Every Mobile Handset is independent and if
the default settings are not desired, the admin options must be set in
each Mobile Handset requiring different settings.

Opening the Admin Menu

With the Mobile Handset powered OFF, simultaneously press and hold
Step 1
the Power ON and Power OFF keys.
Release the Power On key, wait for a single beep, then release the
Step 2
Power Off key. The Admin Menu displays.
If an admin password has been set, the display will require its entry before opening
the Admin Menu. If no password is set, the display will proceed directly into the
Admin Menu.
"User-defined Preferences" on page 4-
4-1