Table of Contents
Advertisement
Take the following steps for easy network security settings.
1. Press the WPS button of the access point to which you want
to connect.
or
Click the PBC configuration button on the management
screen of the access point.
2. Select the desired access point from the list.
3. Click the WPS button on the screen, or double-clicking on the
selected access point.
Notes: 1. This connection procedure must be done within
2 minutes after pressing the WPS button on the access
point.
2. For detailed instructions, refer to the user manual of the
access point device.
Network type - Shows the network type. See "Configuration" on
page 17.
Network name – Service Set ID. (See "Configuration" on
page 17 for details.)
Mode - Shows the wireless connection mode. "B" means the
network is operating in 802.11b mode. "G" means the network is
operating in 802.11g mode. "N" means the network is operating in
802.11n mode.
WPS - Shows WPS status of the access point. A check mark
indicates the WPS function is enabled. If the PIN method is in use
a "PIN" will be displayed. If PBC is enabled, a "PBC" will be
shown on the screen.
Site Survey
31
Advertisement
Table of Contents
