Configuration For Wired Operation Via Tv User Interface - SMC Networks WMR-AG - annexe 1 Manual

Configuration for Wired Operation via TV User Interface

Configuration for Wired Operation via TV
User Interface
Note: You will need your SMCWMR-AG Universal Wireless Multimedia Receiver
Remote Control if you wish to make changes to the default settings.
Step 1: Turn on the SMCWMR-AG. By default, the SMCWMR-AG
Universal Wireless Multimedia Receiver will be configured for connection to your
SMC2804WBR Barricade™ g 2.4GHz 54Mbps Wireless Broadband Router
and SMC2304WBR-AG EZ-Stream™ Universal Wireless Broadband Router.
The default settings are as follows:
•
•
•
•
•
Step 2: If your network is not configured as specified in Step 1, you will need
to configure the SMCWMR-AG to properly establish a connection to your wired
network.
Step 3: The SMCWMR-AG will automatically ask you to reconfigure your
settings if it was not able to get connected with the default settings.
Step 4: Please answer the on-screen questions to complete the setup.
a) [Network Interface]
Select [Use Wired (Ethernet)] to use a wired network. Remember, to
make a selection, press the [OK] button on your Remote Control.
b) [DHCP server present?]
Select [Yes] if you have a DHCP server on your network that will allow
the SMCWMR-AG to obtain an IP address automatically. If you do
not have a DHCP server on your network, select [No] and input your
IP, Subnet Mask, and Gateway addresses.
SSID: [SMC]
WEP: [Disabled]
Internet Proxy: [Disabled]
IP Address: [192.168.2.45]
Mode: [Infrastructure]
23