Setup
Step 3: Connect the power cable from the back of the SMCWMR-AG Universal
Wireless Multimedia Receiver to the nearest power outlet or, preferably, a fused
power strip and switch on your stereo or Audio/Video receiver. Do not forget to
set the receiver to the output mode that corresponds to the jacks you used for
connection to the SMCWMR-AG.
Setting up the Remote Control
Step 1: Open the battery cover on the back of the SMCWMR-AG Universal
Wireless Multimedia Receiver Remote Control.
Step 2: Insert two AA batteries (supplied) by matching the + and - on the
batteries, with the diagram inside the battery compartment.
Configuration for Wireless Operation via
TV User Interface
Note: You will need your SMCWMR-AG Universal Wireless Multimedia
Receiver Remote Control if you wish to make changes to the default settings.
Step 1: Turn on the SMCWMR-AG. By default, the SMCWMR-AG
Universal Wireless Multimedia Receiver will be configured for connection to your
SMC2804WBR Barricade™ g 2.4GHz 54Mbps Wireless Broadband Router
and SMC2304WBR-AG EZ-Stream™ Universal Wireless Broadband Router.
The default settings are as follows:
•
•
•
•
•
Step 2: If your network is not configured as specified in Step 1, you will need to
configure the SMCWMR-AG to properly establish a connection to your wireless
network.
Step 3: The SMCWMR-AG will automatically ask you to reconfigure your
settings if it was not able to get connected with the default settings.
20
SSID: [SMC]
WEP: [Disabled]
Internet Proxy: [Disabled]
IP Address: [192.168.2.45]
Mode: [Infrastructure]