Industry Canada Statement; Ec Declaration Of Conformity - SMC Networks WIPCAM-PZ Manual

Industry Canada Statement

Operation is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference, including interference that may cause undesired operation of the
device
To prevent radio interference to the licensed service, this device is intended to be operated indoors and away
from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors
is subject to licensing.
This device has been designed to operate with an antenna having maximum gain of 1.5dBi.
Any antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the EIRP is not more than required for successful communication.

EC Declaration of Conformity

SMC contact for these products in Europe is:
SMC Networks Spain, S.L.
Edificio Conata II,
Group CTSG
Fructuos Gelabert 6-8 2o2a
08970 Sant Joan Despi, Barcolona,Spai
Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive
of the European Union (1999/5/EC). This equipment meets the following conformance standards.
EN 55022:2006 Class B
EN 61000-3-2: 2006
EN 61000-3-3:1995 +A1: 2001+A2:2005
EN 60950-1:2001+A11:2004
NCC Statement
依據 低功率電波幅射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者不得擅自
變更頻率、加大功率或變更原設計之特性及功能
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現
象時，應立即使用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業、
科學及醫療用電波幅射性電機設備之干擾。
n
EN55024:1998 +A1:2001 +A2:2003
IEC61000-4-2: 1995 +A1 : 1998 +A2 : 2000
IEC61000-4-3: 2002 +A1 :2002
IEC61000-4-4: 2004
IEC61000-4-5: 1995 + A1 : 2000
IEC61000-4-6: 2003 + A1: 2004
IEC61000-4-8: 1993 + A1 : 2000
IEC61000-4-11: 2004
IEC60960-1:2001
4