SMC Networks 7904BRA3 - annexe 1 Manual page 37

Label
Current ATM VC Table
VPI
VCI
Encapsulation
Channel Mode
Admin Status
Enable NAPT
PPP Settings
Login Name
Password
Connection Type
Idle Time (min)
SMC7904BRA3 User Manual
Fig 3.5.1-1
This table shows the PVCs already existed. It shows the Interface name,
Channel Mode, VPI/VCI, Encapsulation mode, local IP Address, Remote
IP address, etc. The maximum item of this table is eight.
(Virtual Path Identifier) The virtual path between two points in an ATM
network, and its valid value is from 0 to 255
The virtual channel between two points in an ATM network, ranging from
32 to 65535 (1 to 31 are reserved for known protocols)
Choices are LLC and VC-Mux.
There are five choices: 1483 Bridged, 1483 MER, PPPoE, PPPoA and
1483 Routed.
If select Disable, this PVC is unavailable.
Select it to enable the NAPT functions of the MODEM. If you are not to
enable NAPT and intend the user of the MODEM to access the Internet
normally, you must add a route on the uplink equipment; otherwise the
access to the Internet fails. Normally, it is required to enable NAPT.
-
The correct user name that your ISP has provided to you.
The correct password that your ISP has provided to you
The choices are Continuous, Connect on Demand and Manual.
If select Connect on Demand, you need to input the idle timeout time.
Within the preset minutes, if the Modem does not detect the flow of the
user continuously, the Modem automatically disconnects the PPPOE
connection.
26
Description