Hardware Setup - SMC Networks 7004ABR Installation Manual

Hardware Setup

1. Connecting Computers: Connect computers directly to the
Barricade on ports 1-4 on the front panel. If you have more than 4
computers to plug in, connect a hub or a switch (using its uplink port)
and connect additional computers to that device.
2. Connecting a Cable Modem or DSL Modem: Connect your Cable
or DSL modem to the WAN port on the rear panel.
3. Connecting a Dial-up Modem: If you use an external dial-up
modem or ISDN modem, connect it to the COM port on the rear
panel.
4. Connecting a Printer: If you have a printer that you want to share
between computers, connect it to the Printer port using a standard
parallel printer cable.
5. Power: Plug the power cord into the power jack.
SMC7004ABR – Front Panel
SMC7004ABR – Rear Panel
4