Table of Contents
Advertisement
A
T
BOUT THE
IGER
Spanning Tree Protocol
The TigerSwitch 10/100 supports IEEE 802.1D Spanning Tree
Protocol. This protocol adds a level of fault tolerance by allowing
two or more redundant connections to be created between a pair
of LAN segments. When there are multiple physical paths between
segments, this protocol will choose a single path and disable all
others to ensure that only one route exists between any two
stations on the network. This prevents the creation of network
loops. However, if the chosen path should fail for any reason, an
alternate path will be activated to maintain the connection.
The default setting for the Spanning Tree Protocol is "enabled."
This protocol may be configured out-of-band via the serial console
port, or in-band via the Web interface, Telnet, or SNMP network
management software.
VLANs
The TigerSwitch 10/100 supports up to 256 VLANs. A Virtual LAN
is a collection of network nodes that share the same collision
domain regardless of their physical location or connection point in
the network. By segmenting your network into VLANs, you can:
•
Eliminate broadcast storms which severely degrade
performance in a flat network.
•
Simplify network management for node changes/moves by
remotely configuring VLAN membership for any port, rather
than having to manually change the node's IP address.
•
Provides data security by restricting all traffic to the originating
VLAN, except where a connection has been configured
between separate VLANs using a router or Layer 3 switch.
1-6
S
10/100
WITCH
Advertisement
Table of Contents
