Setting the Speed Warning
Use this function to set the speed value for
warning, if you exceed this value.
1- Long press COMPUTER.
2- Select SPEED WARN with the
3- Use the
keys to select a speed: 100,
110, 120, 130 or 140 km/h.
4- Press ESC to enter the value.
Note : Speed warning bleeps are generated
with a frequency dependent on the difference
between stored speed and current car speed.
Current source is still audible in background.
Switching the Trip Warning
Use this function to set a trip warning. So, if
you drive more than 2 hours, a warning will
be displayed every 15 minutes.
1- Long press COMPUTER.
2- Select TRIP WARN with the
3- Use the
keys to select ON or OFF to
activate/deactivate the function.
4- Press ESC to enter the value.
Switching the Battery Warning
Use this function to set a battery value for
warning: so, if the battery voltage is below
this value, a warning will be displayed.
1- Long press COMPUTER.
2- Select BAT. WARN with the
3- Use the
keys to set the value.
4- Press ESC to enter the value.
Selecting Infos to be displayed
Use this function to set what will be dis-
played first line after pressing three times, the
DISPLAY key.
1- Long press COMPUTER.
2- Select INFO LINE with the
3- Use the
keys to select the informations
to be displayed: temperature, clock,
speed, time, distance or battery.
4- Press ESC to enter the value.
* Depending on radio reference: see table at the end
22
Starting the Speed Calibration
Use this function to start speed calibration.
1- Long press COMPUTER.
2- Select SPD CALIB with the
keys.
3- Press ENTER to start the calibration.
Note : See Configuration for the complete
calibration process.
Starting PDC Calibration
Use this function to start PDC calibration.
1- Long press COMPUTER.
2- Select PDC CALIB with the
3- Press ENTER to start the calibration.
Resetting the parameters
Use this function to reset the Car Computer
parameters.
1- Long press COMPUTER.
2- Select RESET with the
keys.
3- Press ENTER to launch the resetting.
ANNOUNCEMENTS
You can reach the Announce Menu by a long
press on the SOURCE key (see cover pages).
Updating RDS Dynamic Memory
keys.
You can automatically update all FM memo
stations while listening other sources.
1- Long press SOURCE.
2- Select RDSMEM DYN with the
3- Use the
4- Press ESC to enter the value.
Note : The electric antenna will stay out even
keys.
if the set is OFF when the key is engaged.
Activating the TMC*
Switch ON this function to open the Traffic
Message Channel for sending numeric data
to the dynamic navigation system.
1- Long press SOURCE.
2- Select TMC with the
keys to set the function: ON
(default value) or OFF.
keys.
keys.
keys.
keys.
keys.