Basic Operation - Altec Lansing PT7031 User Manual

Video Connection
TV
VIDEO IN
To connect the video out:
• Using the supplied A/V cable, connect one yellow end to connect the
VIDEO OUT on the PT7031 and the other yellow end to the video
input jack on the TV. This connection allows you to view the on-
screen display (OSD) on your TV screen when the corresponding
input is selected.
Connecting a Subwoofer
PT7031
To connect an optional subwoofer:
• Use an optional commercially available mono audio cable to connect
the SUBWOOFER OUT jack on the rear of the PT7031 to the
SUBWOOFER INPUT jack on the subwoofer.
INPUT
POWERED
SUBWOOFER
AC IN
7
Setting up the Remote Control
Installing Batteries
• Depress the latch on the back of the remote as shown to remove the
battery cover.
• Insert two AAA batteries.
• Close the battery cover.
Notes:
• Change all of the batteries if you notice that the operation range of
the remote decreases or the indicator does not blink or its light
becomes dim.
• Do not use old batteries together with new ones.
• Do not use different types of batteries such as alkaline and
manganese batteries together. Read the packaging carefully as these
different types of batteries may have the same shape and color.
• Exhausted batteries may leak. If the batteries have leaked, dispose of
them immediately. Avoid touching the leaked material or letting it
come into contact with skin or clothing. Clean the battery
compartment thoroughly before installing new batteries.
• Do not throw away batteries with general house waste. Dispose of
them correctly according to local regulations.

Basic Operation

• After all audio and video connections are secure; you can plug in the
PT7031's AC cord into a suitable AC outlet.
• Turn on the power switch on the rear panel of the PT7031 to the on
position. The PT7031 will enter into STANDBY mode. The power LED
on front panel will turn red indicating that the unit is in standby
mode.
• Press the POWER button on the front panel to power on the PT7031.
The power LED will switch from red to green indicating the unit is on.
• Begin playback on the DVD player or other device that you want to
listen to.
• Select the desired input using the INPUT button on the front panel or
remote control. The corresponding LED will illuminate to indicate the
input that has been selected
• Select the desired audio mode by using the MODE button on the
front panel or remote control. For most devices you can choose
between stereo or virtual surround modes.
• Adjust the system volume using the VOL +/– buttons on the remote
control or front panel.