System Messages - Dell Inspiron 1200 Owner's Manual

Light Pattern

System Messages

NOTE:
If the message you received is not listed in the table, see the documentation
for either the operating system or the program that was running when the message
appeared.
C M OS F
A I L U R E
Press <F1> to load defaults.
D
E C R E A S I N G A V A I L A B L E M E M O R Y
page 88.
E 86 02 – A
R R O R
A R E S E C U R E L Y A T T A C H E D T O C O R R E C T C O N N E C T O R S
F
L A S H P A R T W R I T E P R O T E C T E D E R R O R
).
page 129
G A 20
A T E F A I L U R E
74
Troubleshooting Tools
Problem Description
Memory subsystem
configuration activity
is in progress or a
memory failure was
detected.
The system is in flash
recovery mode.
No LCD panel
detected or LCD self-
test failure occurred.
EEPROM SPD data
indicates all
SODIMMS are
unusable.
Possible system board failure or the RTC battery is low.
—
U X I L L I A R Y D E V I C E F A I L U R E V E R I F Y T H A T M O U S E A N D K E Y B O A R D
See "Lockups and Software Problems" on page 88.
—
Suggested Resolution
• If available, install working memory of
the same type into your computer (see
your Service Manual).
• If the problem persists, contact Dell
(see "Contacting Dell" on page 129).
Contact Dell (see "Contacting Dell" on
page 129).
• Reseat the LCD cable (see your
Service Manual).
• If the problem persists, contact Dell
(see "Contacting Dell" on page 129).
• If available, install working memory of
the same type into your computer (see
your Service Manual).
• If the problem persists, contact Dell
(see "Contacting Dell" on page 129).
See "Lockups and Software Problems" on
—
.
Contact Dell (see
—
"Contacting Dell" on