BALAY 3TI60081A Installation And Operating Instructions Manual page 17

Filter in the water inlet
*Water inlet hose depending on model
Cleaning the filter on the tap
Cleaning the filter on the washing machine
Cleaning the filter on the washing machine
If no water, or an insufficient amount of water, runs into the washing
machine, first release the water pressure in the inlet hose:
 Turn off the water tap.
 Select any programme (except O/C (Rinse + Spin) /
 Press the ! inicio/pausa (Start/Pause) button.
 Allow the programme to run for approximately 40 seconds.
 Set the programme selector to stop (Off).
 Unplug the mains plug from the socket.
 Unscrew the water inlet hose from the tap.
 Clean the filter with a small brush.
 Reconnect the hose.
 Turn on the water tap.
 Check whether water comes out of the end of the hose.
 If water is escaping, check that the filter is correctly seated.
 Remove the hose from the water tap.
 Rinse out the filter under running water.
 Connect the hose.
 Remove the hose from the rear of the washing machine.
 Pull out the filter and rinse out under running water.
 Insert the filter and connect the hose.
 Turn on the tap and check whether water still escapes. If water still
escapes, check that the filter is seated correctly.
 Turn off the water tap.
/D
t
(Empty).
17