Changing Snap-On Presser Feet - Singer 5040 Instruction Manual

Changing snap-on presser feet

(B), (D), (J), (L)
• Raise needle to its highest position by turn-
ing hand wheel toward you.
• Raise presser foot using presser foot lifter at
back of machine.
• Push toe of presser foot (1) up, until it
snaps off the shank (2).
• Remove foot from machine.
• Place new foot under centre of shank.
• Lower presser foot litter, fitting shank over
presser foot pin (3).
• Don't turn screw. Instead, push presser foot
screw (4) down, firmly until foot snaps into
place.
13