Using The T 775 - Setup Menu; Setup Menu; Source Setup; Source Setup (Normal View) - NAD T775 HD Owner's Manual

SETUP MENU

The Setup Menu allows one to customize the operation of the T 775 to the
ancillary equipment used in one' s specific AV system. Unless your system
exactly matches the factory defaults as shown in the accompanying Quick
Start Guide, you will need to use the setup menu to configure the inputs of the
T 775.
At Setup Menu, the following are configurable – Source Setup, Speaker
Setup, Zone Setup, Amplifier Setup, Trigger Setup, Listening Mode Setup,
Display Setup and A/V Presets.
To access and navigate through Setup Menu and its sub-menu selections,
please refer to and follow the directions stated in the sections 'Display the
OSD' and 'Navigating the OSD and Making Changes. '

SOURCE SETUP

From Setup Menu, pressing will direct you to the Source Setup menu
wherein you could adjust allocate or change the settings of the following
– Source Setup (Normal View), Source Setup (Table View) and iPod Setup.

SOURCE SETUP (NORMAL VIEW)

The Source Setup (Normal View) menu makes it possible to set, allocate or
change the following settings.
USING THE T 775 – SETUP MENU
SOURCE
The T 775 is equipped with ten configurable Sources. The settings for each
Source are dependent on the configurations set forth in the parameters for
that particular Source window.
To change or toggle through the Sources, scroll to 'Source' , press
and then ENTER or to move up or down the Source selections.
NOTE
Source 5 is defaulted to iPod. For Source 5 to be changed and allocated
for other inputs, go to 'iPod Setup' menu under the 'Source Setup' menu.
At iPod Setup menu, set 'Enabled' to 'No' – you can now assign Source 5
to other inputs or settings as desired.
ENABLED
One can enable/disable a Source via this option. This is particularly useful
if only few Sources are used and one directly selects the Source from the
front panel, bypassing unused sources.
To enable or disable a particular Source, scroll to 'Enabled' and press
keys to select 'Yes' or 'No' .
NAME
A new Name maybe assigned to a Source label. For example, if your DVD
player is attached to 'Source 1' , it is possible to rename 'Source 1' to 'DVD
Player. '
In order to rename the Source label, scroll to 'Name' and press
character. Then, press to pick through the alphanumeric selections.
Press to move to the next character and at the same time save the
changes done on the current character. The name can be as long as twelve
characters.
The new Name will be shown in the VFD as well as on the OSD.
OPERATION
button
to go the
17