Source Setup; Source Setup (Normal View) - NAD T747 Owner's Manual

5 With the above settings, scroll to "A/V Presets" from the SETUP MENU
page. Use [ ] to access "A/V Presets" menu.
6 At "A/V Presets" page, set "Preset: 2" to the following conditions:
Use [ ] to select "Yes" or "No" and press [ENTER] to confirm selection
and move to the next setting
While at "Save Current Setup to Preset" menu line, use [
settings above to "Preset 2". When you recall "Preset 2" using the remote
control (for AVR 3, "A/V PSET" + "2"), the above preset values allocated at
"Preset 2" (preset settings as shown in the OSD captures at Step D) will
be recalled and effected at the current source.
Note that "Speaker Setup" is set to "No". At this condition, there will
be no "Speaker Setup" values that will be effected at "Preset 2". The
"Speaker Setup" settings that will be applied at "Preset 2" will be the last
or current "Speaker Setup" settings which in this sample are the same
"Speaker Setup" settings shown above in Step 1.
7 You can setup up to 5 Presets. These same Presets can also be
associated/defaulted to each Source in the "Source Setup (Normal
View)" window as below
In the above example, "Preset 1" settings are allocated for Source 1.
Whenever Source 1 is accessed, the "Preset 1" settings will be applied to
Source 1. You can still manually override the assigned Preset allocation
in a specific Source with another Preset setting/number by way of
pressing the appropriate remote control buttons.
RECALLING PRESETS
You may recall a Preset at any time using the AVR 3 remote control.
Press the AVR 3's A/V PSET key and then the numeric key 1-5 corresponding
to the desired preset number. The newly recalled Preset will then manifest
or replace the previous Preset (if any).

SOURCE SETUP

] to save the
From Source Setup menu, pressing [
menu wherein you could adjust allocate or change the settings of the
following – Source Setup (Normal View), Source Setup (Table View) and
iPod Setup.

SOURCE SETUP (NORMAL VIEW)

The Source Setup (Normal View) makes it possible to set, allocate or change
the following settings.
OPERATION
USING THE T 747 – SETUP MENU
] will direct you to the Source Setup
1