APRILIA RX 50 - 1996 Manual page 40

CHANGING THE HEADLIGHT BULBS
(Fig. 38)
To change the low and high beam bulbs, proceed
as follows:
Remove the rubber cup (1);
Remove the connector;
Act on the "V"-spring and extract the socket with
the bulb;
Replace the damaged bulb;
To reassembly, carry out the same operations re-
versing the order.
To change the parking light bulb, proceed as fol-
lows:
Remove the rubber socket (2) and extract the bulb;
If it is damaged, replace the bulb.
CHANGING THE REAR LIGHT BULBS
(Fig. 39)
Proceed as follows:
Unscrew the two screws (1);
Remove the glass (2);
Press the bulb slightly and rotate it anticlockwise;
c
Remove the bulb from its seat.
The introduction of a new bulb can be car-
ried out in one sense only, since the two
guide pins are misaligned.
Install a new bulb correctly, then repeat the above
operations in the reverse order for the reassem-
bly.
Fig. 37
Fig. 38
39