ZyXEL Communications ZYWALL - CLI Reference Manual page 356

Chapter 43 Maintenance Tools
Router# traceroute www.zyxel.com
traceroute to www.zyxel.com (203.160.232.7), 30 hops max, 38 byte packets
1 172.23.37.254
2 172.23.6.253
3 172.23.6.1
4 * * *
Here are maintenance tool commands that you can use in configure mode.
Table 197 Maintenance Tools Commands in Configuration Mode
COMMAND
show arp-table
arp IP mac_address
no arp ip
The following example creates an ARP table entry for IP address 192.168.1.10 and MAC
address 01:02:03:04:05:06. Then it shows the ARP table and finally removes the new entry.
Router# arp 192.168.1.10 01:02:03:04:05:06
Router# show arp-table
Address
192.168.1.10
172.23.19.254
Router# no arp 192.168.1.10
Router# show arp-table
Address
192.168.1.10
172.23.19.254
43.0.1.1 Packet Capture Command Example
The following examples show how to configure packet capture settings and perform a packet
capture. First you have to check whether a packet capture is running. This example shows no
other packet capture is running. Then you can also check the current packet capture settings.
Router(config)# show packet-capture status
capture status: off
Router(config)#
Router(config)# show packet-capture config
iface: wan1,lan2,wan2
ip-type: any
host-port: 0
host-ip: any
file-suffix: Example
snaplen: 1500
duration: 150
file-size: 10000
split-size: 2
ring-buffer: 0
storage: 0
356
3.049 ms 1.947 ms
2.983 ms 2.961 ms
5.991 ms 5.968 ms 6.984 ms
DESCRIPTION
Displays the current Address Resolution Protocol table.
Edits or creates an ARP table entry.
Removes an ARP table entry.
HWtype HWaddress
ether 01:02:03:04:05:06
ether 00:04:80:9B:78:00
HWtype HWaddress
(incomplete)
ether 00:04:80:9B:78:00
1.979 ms
2.980 ms
Flags Mask
CM
C
Flags Mask
C
ZyWALL (ZLD) CLI Reference Guide
Iface
ge1
ge2
Iface
ge1
ge2