ZyXEL Communications PLA4201 User Manual page 46

Chapter 6 LEDs and Troubleshooting
The POWER lights on both devices blink, then many lights blink and the HomePlug light blinks
red.
Do not worry, the connection process is proceeding normally.
The POWER lights on both devices finished blinking, but only one device's HomePlug light is
on.
One device may have connected to a third powerline device. To check device A is connected to
device B and not another device, disconnect device B from its power source. Device A's HomePlug
( ) light will turn off if the connection is with Device B. Press the RESET/ENCRYPT button on
both devices for 5 to 8 seconds, then try to reconnect, pressing the RESET/ENCRYPT button for
0.5 to 3 seconds on both devices.
I pressed the RESET/ENCRYPT button for 5 to 8 seconds, but the HomePlug light is still on.
The HomePlug light is on, indicating it is still connected to another powerline device. Try again,
pressing the RESET/ENCRYPT button for 5 to 8 seconds.
46
PLA4201 User's Guide