ZyXEL Communications P660HW-DX V2 - V3.40 User Manual page 196

Chapter 13 Bandwidth Management
Table 78 Bandwidth Management Rule Configuration (continued)
LABEL
DiffServ mark
Filter Configuration
Service
Destination
Address
Destination Subnet
Netmask
Destination Port
Source Address
Source Subnet
Netmask
Source Port
Protocol
TOS (Type of
Service)
TOS Mask
Back
196
DESCRIPTION
Select the marking rule from the drop-down list. The first three digits are the
DiffServ code point. A packet with the lowest priority mark will be dropped when
the line is busy.
This field simplifies bandwidth class configuration by allowing you to select a
predefined application. When you select a predefined application, you do not
configure the rest of the bandwidth filter fields (other than enabling or disabling
the filter).
SIP (Session Initiation Protocol) is a signaling protocol used in Internet
telephony, instant messaging and other VoIP (Voice over IP) applications.
Select SIP from the drop-down list box to configure this bandwidth filter for traffic
that uses SIP.
File Transfer Protocol (FTP) is an Internet file transfer service that operates on
the Internet and over TCP/IP networks. A system running the FTP server
accepts commands from a system running an FTP client. The service allows
users to send commands to the server for uploading and downloading files.
Select FTP from the drop-down list box to configure this bandwidth filter for FTP
traffic.
H.323 is a standard teleconferencing protocol suite that provides audio, data
and video conferencing. It allows for real-time point-to-point and multipoint
communication between client computers over a packet-based network that
does not provide a guaranteed quality of service. Select H.323 from the drop-
down list box to configure this bandwidth filter for traffic that uses H.323.
Select User defined from the drop-down list box if you do not want to use a
predefined application for the bandwidth class. When you select User defined,
you need to configure at least one of the following fields (other than the Subnet
Mask fields which you only enter if you also enter a corresponding destination or
source IP address).
Enter the destination IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination Address. Refer to the appendices for more information on IP
subnetting.
Enter the port number of the destination. See
common services and port numbers. A blank destination IP address means any
destination IP address.
Enter the source IP address in dotted decimal notation. A blank source IP
address means any source IP address.
Enter the destination subnet mask. This field is N/A if you do not specify a
Source Address. Refer to the appendices for more information on IP
subnetting. A blank source port means any source port number.
Enter the port number of the source. See
common services and port numbers.
Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number. 0 means any protocol number.
TOS defines the DS (Differentiated Service) field in the IP header.
Enter the new TOS value of the outgoing packet (between 0 and 255). 0 is the
lowest priority.
The TOS mask is used to compare the specified (or entire) bits in the TOS IP
header with the value specified in this rule.
Enter the TOS Mask value between 0 (lowest priority) and 255.
Click Back to go to the previous screen.
Table 79 on page 197 for some
Table 79 on page 197 for some
P-660HW-Dx v2 User's Guide