Page 1
Operating Manual PORTABLE LCD DVD PLAYER Model: MES-221 For information and support, www.lenco.eu READ THESE INSTRUCTIONS INCLUDED IN THIS IM THOROUGHLY PRIOR TO CONNECTING AND OPERATING. PLEASE RETAIN THIS MANUAL IN CASE YOU MAY NEED IT FOR FUTURE REFERENCE. THE ILLUSTRATIONS & GRAPHICS HEREIN ARE FOR REFERENCE ONLY AND SUBJECT TO CHANGE WITHOUT NOTICE.
TABLE OF CONTENTS OVERVIEW OF THE DVD PLAYER...............................2 SLAVE SCREEN ....................................2 REMOTE CONTROL UNIT ................................2 BASIC CONNECTION..................................3 Connecting to a stereo TV set ................................3 Connecting to a an affiliated screen ...............................3 OPERATIONS....................................4 PREPARATION ....................................4 GET STARTED ....................................4 ADJUST THE VOLUME ................................4 MUTE ......................................4 SKIP AHEAD OR BACK.................................4 RAPID ADVANCE/ REVERSE ...............................4...
BASIC CONNECTION It is recommended to connect a multi-system TV. Ensure that this player and other equipment to be connected are set to the standby mode or off and disconnect the AC power cords before commencing connection. Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely. Read through the instructions before connecting other equipment.
ON SCREEN DISPLAY INFORMATION OPERATIONS When the player is in operation press the display button PREPARATION continuously on the remote control. The screen will display Power on the TV set and select video input mode. information about the: Title elapse, Title remain, Chapter elapse Power on the audio system which is connected to the player.
MP3/MPEG 4 PLAYBACK INITIAL SETTINGS Load the MP3/MPEG 4 disc onto the disc tray and the TV Initial settings page is for you to make your preferred settings up screen will show all its folders after a few seconds. for your player. Once the initial settings are done they are Select the folder you want by the navigation buttons and retained in the CPU of the player until otherwise modified.
3. VIDEO QUALITY SETUP 5.2.1 OLD PASSWORD 5.2.2 NEW PASSWORD 5.2.3 CONFIRM PASSWORD Procedure to change password: 1) Enter old password in the OLD PASSWORD row 2) Enter new password in the NEW PASSWORD row 3) Enter the new password again in the CONFIRM PASSWORD You may reset the password if you forget the old password by using the supervisor password: 1389...
If you have questions regarding the warranty, the length of warranty and the working method of it, you can find the information on our site www.lenco.eu or you can directly contact the place where you purchased your product. If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste.