LENCO MES-202 - MANUEL 2 Operating Manual

Portable lcd dvd player
Hide thumbs Also See for MES-202 - MANUEL 2:

Advertisement

Quick Links

Operating Manual
PORTABLE LCD DVD PLAYER
Model: MES-202
READ THESE INSTRUCTIONS INCLUDED IN THIS IM THOROUGHLY PRIOR TO CONNECTING AND OPERATING.
PLEASE RETAIN THIS MANUAL IN CASE YOU MAY NEED IT FOR FUTURE REFERENCE.
THE ILLUSTRATIONS & GRAPHICS HEREIN ARE FOR REFERENCE ONLY AND SUBJECT TO CHANGE WITHOUT NOTICE.
0

Advertisement

Table of Contents
loading

Summary of Contents for LENCO MES-202 - MANUEL 2

  • Page 1 Operating Manual PORTABLE LCD DVD PLAYER Model: MES-202 READ THESE INSTRUCTIONS INCLUDED IN THIS IM THOROUGHLY PRIOR TO CONNECTING AND OPERATING. PLEASE RETAIN THIS MANUAL IN CASE YOU MAY NEED IT FOR FUTURE REFERENCE. THE ILLUSTRATIONS & GRAPHICS HEREIN ARE FOR REFERENCE ONLY AND SUBJECT TO CHANGE WITHOUT NOTICE.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS IN THE BOX ....................................2 OVERVIEW OF THE DVD PLAYER ............................... 3 SLAVE SCREEN .................................... 3 REMOTE CONTROL UNIT ................................3 BASIC CONNECTION..................................4 Connecting to a stereo TV set ................................ 4 Connecting to a an affiliated screen ............................... 4 OPERATIONS ....................................
  • Page 3 IN THE BOX You should have the following items in the packaging: Main Portable DVD player / Screen Unit Slave Screen Cigarette Lighter Plug 1PCS 1PCS 1PCS AV Cable Slave Screen Power Connector Cable Remote Control 1PCS 1PCS 1PCS Carry Bag Vehicle Headrest Attachment Strap Instruction Manual 1PCS...
  • Page 4: Overview Of The Dvd Player

    OVERVIEW OF THE DVD PLAYER: 1. TFT SCREEN 2. LEFT&RIGHT SPEAKERS 3. PLAY/PAUSE BUTTON 4. STOP BUTTON 5. PREVIOUS&F.BWD BUTTON 6. NEXT&F.FWD BUTTON 7. SETUP BUTTON 8. SUBTITLE BUTTON 9. VOL- BUTTON 10. VOL+ BUTTON 11. REMOTE SENSOR 12. DC 9V IN & CAR PLUG 12V IN SOCKET 13.
  • Page 5: Basic Connection

    BASIC CONNECTION Mains plug or appliance connector shall be used as the disconnect device, so mains plug or appliance connector should always remain readily operable. It is recommended to connect a multi-system TV. Ensure that this player and other equipment to be connected are set to the standby mode or off and disconnect the power cords before commencing connection.
  • Page 6: Operations

    ON SCREEN DISPLAY INFORMATION OPERATIONS When the player is in operation press the display button PREPARATION continuously on the remote control. The screen will display Power on the TV set and select video input mode. information about the: Title elapse, Title remain, Chapter Power on the audio system which is connected to the player.
  • Page 7: Mp3/Mpeg 4 Playback

    MP3/MPEG 4 PLAYBACK INITIAL SETTINGS Load the MP3/MPEG 4 disc onto the disc tray and the TV Initial settings page is for you to make your preferred settings screen will show all its folders after a few seconds. up for your player. Once the initial settings are done they are Select the folder you want by the navigation buttons and retained in the CPU of the player until otherwise modified.
  • Page 8: Video Quality Setup

    3. VIDEO QUALITY SETUP 5.2.1 OLD PASSWORD 5.2.2 NEW PASSWORD 5.2.3 CONFIRM PASSWORD Procedure to change password: 1) Enter the old password in the OLD PASSWORD row 2) Enter the new password in the NEW PASSWORD row 3) Enter the new password again in the CONFIRM PASSWORD row You may reset the password if you forget the old password by using the supervisor password: 1389...
  • Page 9: Troubleshooting

    TROUBLESHOOTING If your DVD player does not seem to be functioning properly, check the items below before you contact an authorized service center Symptom Check Power does not turn on or suddenly Make sure the car adapter is securely plugged into cigarette lighter socket. turns off.
  • Page 10: Installation Of The Portable Dvd Player In A Vehicle

    Installation of the portable DVD player in a vehicle WARNING - On no account should this unit be used by the driver of a moving vehicle, or left unsecured in the vehicle whilst driving. - If this unit is being used by a passenger, ensure that it is secured or held safely, and that it does not obstruct any safety devices (eg.

Table of Contents