Video Quality Setup; Preference Setup; Password Setup; Disc Handling Precautions - LENCO MES-202 Operating Manual

3. VIDEO QUALITY SETUP

3.1 SHARPNESS -to set the sharpness for the display.
Options: HIGH MEDIUM LOW
3.2 BRIGHTNESS -to set the brightness for the display.
3.3 CONTRAST -to set the contrast effect for the display.
3.4 GAMMA -to set the Gamma effect for the display.
Options: HIGH MEDIUM LOW NONE
3.5 HUE -to set the hue for the display.
3.6 SATURATION -to set the saturation for the display.
3.7 LUMA DELAY
Options: 0T 1T

4. PREFERENCE SETUP

The first power on this set by press the power button on the
front plane without placing any disc on this tray, press the setup
button, then you can enter the Preference Page by pressing the
navigate button .
4.1 TV TYPE -it is used to select the TV mode.
Options: PAL/AUTO/NTSC
Select the option that is supported by your TV.
4.2 AUDIO -select preferred audio language.
(DVD only -need disc software support)
4.3 SUBTITLE -select preferred subtitle language.
(DVD only -need disc software support)
4.4 DISC MENU -select preferred disc menu language.
(DVD only -need disc software support)
4.5 PARENTAL -select rating levels. You must set the
PASSWORD MODE ON and then enter the password to
enablethis selection. (DVD only -need disc software support)
4.6 DEFAULT -Reset to factory settings.

5. PASSWORD SETUP

5.1 Password MODE
Options: ON/OFF
5.2 PASSWORD CHANGE
Option: Change Select to change password
5.2.1 OLD PASSWORD
5.2.2 NEW PASSWORD
5.2.3 CONFIRM PASSWORD
Procedure to change password:
1) Enter the old password in the OLD PASSWORD row
2) Enter the new password in the NEW PASSWORD row
3) Enter the new password again in the CONFIRM
PASSWORD row
You may reset the password if you forget the old password by
using the supervisor password: 1389

Disc Handling precautions

Hold the disc by the edge so the surface
will not be soiled with finger prints.
Finger prints, dirt and scratches can
cause skipping and distortion.
Do not write on the label side with a
ball-point pen or other writing utensils.
Do not apply benzine, thinner, and liquid
that prevents against static electricity.
Be careful not to drop or bend the disc.
Instal only one disc on the disc tray.
Do not try to close the disc tray when the
disc is not in stalled properly.
Be sure to store the disc in it's case
when not in use.
6