Aiwa NSX-A111 Operating Manual page 14

Aiwa srereo system operating manual 8z-nfa-914-01 9901
Hide thumbs Also See for NSX-A111:
Table of Contents

Advertisement

Available languages

Available languages

The clock is displayed.
(The ":" between the hours and minutes
flashes.)
When the power cord is plugged
into an AC outlet
for the first time after purchase
or when the clock setting
is
canceled
due to a power
failure,
the entire
clock
display
flashes.
1 Press CLOCK while pressing SHIFT,
2 Within 4 seconds, press -
or -to
designate
the hour and the minute.
Pressing
either button changes
both the hour and the minute,
Holding it down will vary the time rapidly by 10-minute
interval,
and pressing
it repeatedly
will vary by 1 minute interval.
3 Press Il.
The clock starts from 00 seconds.
To restore an original clock setting
Press
CLOCK
while pressing SHIFT on the remote control before
completing
step 3 to restore
the previous
time setting.
This
cancels
any new setting.
To view the clock when another display is in the display
Press
CLOCK
while pressing
SHIFT on the remote control. The
time is displayed
for 4 seconds
and then the original
display
reappears,
However,
the clock
cannot
be displayed
during
recording.
To switch to the 24-hour standard
Press
CLOCK
while pressing
SHIFT on the remote control and
then press
within 4 seconds.
Repeat the same procedure
to restore the 12-hour standard.
2—
The unit can be turned off automatically
at a specified
time.
Use the remote control.
1
2
Press SLEEP while pressing SHIFT.
Within 4 seconds,
press 4
or ~
to specify
the time until the power is turned off.
The time changes
between
5 and 240 minutes
in 5-minute
steps.
Specifi~d
time
While the timer is in operation,
the display
indication
is dimmer
than usual.
To check the time remaining until the power is turned off
Press
SLEEP
once while pressing
SHIFT. The remaining
time is
displayed
for 4 seconds.
To cancel the sleep timer
Press
SLEEP
twice while pressing
SHIFT
so that "SLEEP
oFF
appears
on the display.
~
If the display flashes when the clock is displayed,
it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
I 4
ENGLISH

Advertisement

Table of Contents
loading

Table of Contents