Sceptre X42GV-Naga User Manual page 79

Problems
Blinking picture
accompanied
by signal box image
Broken lines or
segments
Certain TV channels
are
blocked
Can not access a
picture or
audio menu
Cannot view 2 channels
at the
same time with PIP
Universal Remote Code
TV has colors of lines
across the screen
TV is turned on, stand
by light is green but no
picture
No Picture on PC (DVI Is your video card's DVI port turned off by default?
SCEPTRE X42
Check the connection of antenna/signal cable
Adjust antenna. Keep the TV away from noise sources such as
neon lights, and hair dryer.
Please use the channel scanning function or v-chip function to
unblock.
Make sure your Picture / Sound are both on "User Mode" by
pressing the "Picture" button until the upper left hand corner
says "User Mode".
Please do the same regarding "Sound" button
The PIP function is not designed to view 2 channels at the same
time.
This television is designed with SONY television universal
remote codes.
This is a big LCD screen, it takes time for electricity to charge
up to power the screen and takes time for the large screen to
deplete all it's residual electricity.
Please do not turn the TV on and off really quickly.
Between the time which you turn off the TV and the time
which you turn it on, there should be at least 50 seconds to 70
seconds.
This is a big LCD screen, and needs time to warm up to show
the picture.
Please wait for 15-30 seconds for the picture to show up.
Possible solutions
Page79