Connecting The Fm,Am(Mw)And Sw(Option) Antennas - Samsung MAX-DS960 Instruction Manual

Connecting the FM, AM ( MW/LW ) and SW(option) Antennas
FM Antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
Cooling Fan
normally. The cooling fan is activated automatically to supply cool air to the unit.
If AM reception is poor, connect an
outdoor AM antenna(not supplied).
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit
could rise and may damage it.
•
Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are
covered with a newspaper or cloth, heat may build up inside the unit and fire may result.)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
Spread the SW aerial out and attach the
ends to a wall, in the position providing the
best reception.
If reception is poor (e.g. distance from
transmitter too great, walls blocking the
radio waves, etc.), install an outdoor aerial.
AM antenna connection
(MW/LW)
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
AM Loop Antenna
(supplied)
14