Chapter 8: Installation; Introduction - Raymarine SL70RC PLUS Series User Manual

Chapter 8: Installation

Chapter 8: Installation

8.1 Introduction

This chapter provides installation instructions for your SL70RC PLUS series
display. Details for mounting the SL70RC PLUS series display and
connecting the equipment are included. A typical system is illustrated in
Figure 8-1.
• To install the display unit follow the instructions in Section 8.2 to
Section 8.6.
You should then test the display as described in Section 8.7.
• To connect your display to other equipment, follow the guidelines in
Section 8.8 and Section 8.9, taking particular care to ensure the correct
polarity of the SeaTalk supply.
• Details on installing the scanner are provided in the Pathfinder Plus
Radar Scanner Owner's Handbook.
Scanner
Compass
Figure 8-1:
Note: If you wish to practice using the display before installation, connect a
12V or 24V DC power supply (connecting the red wire via a 6.3A quick blow
fuse to positive and the black wire to negative) and using the simulator mode,
as described in Chapter 2.
Display Unit
NMEA
12/24V Supply
12V Supply
Typical System
Junction
Box
SeaTalk
Distribution Panel
12V Supply
8-1
GPS
D4288-2