Pioneer Elite PRO-110FD Operating Instructions Manual page 22

Preparation
05
speaker cables
Connecting the speaker cables
to the rear of plasma display.
Connect the cables correctly with respect to
the polarity of the plasma display speaker
terminals, that is,  cable (Gray) to 
terminals (Red) and  cable (Black) to 
terminals (Black).
Speaker terminal
Note
• Press the lever and insert the end of the cable.
• When you release the lever, it
clamps onto the speaker cable.·
Caution
• Be sure to turn the connected
devices off and remove the power
cord from the wall outlet beforehand when changing the
connection or installation method.
• If you insert the speaker cable too far so that
the insulation is touching the speaker
terminal, you may not get any sound.
22
En
Gray Black Gray
Red Black Red
Speaker cable
Lever
Connecting the speaker cables
to the speaker.
Black
Black
Connect the cables correctly with respect to
the polarity of the speaker terminals, that is,
 cable (Gray) to  terminals (Red) and 
cable (Black) to  terminals (Black).
Speaker terminal
• Check if the end of the speaker cables are securely connected
to the terminals by slightly tugging on the cable after making
connections. Loose connections may result in sound dropouts
or noise.
• If there is a short in the  and  cables caused by an exposed
lead wire, excessive load may be applied to the plasma display,
resulting in interrupted operation or malfunction.
• Incorrect connections of the speaker cable to the right or left of
the plasma display terminals with respect to the polarity may
result in insufficient stereo sound effects, delivering poor bass
sounds or unstable sound image.
• Bundle the cable without pulling.
Red
Gray
Speaker terminal