Pioneer Elite PRO-110FD Operating Instructions Manual page 18

Preparation
05
Attaching the light-blocking shield (PRO-150FD only)
This part prevents reflection of the cables connected to the back
of the plasma display on the base cover.
Note
• Attach it after anchoring the base cover on a flat stable place.
Rear
1 Remove the double-sided adhesive tape from
the light-blocking shield.
Remove each double-sided
adhesive tape.
18
En
Light-blocking shield
Front
Base cover
2 While firmly holding the ends of the light-
blocking shield, apply it with the double-
sided adhesive tape.
Rear
Note
• Be careful that the light-blocking shield does not catch on the
pipe insertion holes.
• Anchor it in place so that there are no gaps (See diagram at
below). If there is a gap, the light-blocking shield may peel off.
3 Anchor it in place while pressing it down
from above.
Rear
Press
Press
Front
Front
Be sure that
there is no gap.