Function Rename - Pioneer Elite VSX-55TXi Operating Instructions Manual

Fine Tuning Your System

Function Rename

Use the FUNCTION RENAME capability to rename the display on the receiver and your OSD for different functions
(DVD, etc.). For example, you could rename VCR1/DVR as DVR-7000. For this particular setup using the controls on
the front panel is more convenient than using the remote control. Use the MULTI JOG dial instead of the 
buttons and use the ENTER button on the front panel. You can also use the display on the front panel as opposed to
the OSD.
1 Turn on the receiver and your TV.
(If you want to use the remote
control for this setup, press the
RECEIVER button.)
2 Press the SET UP button.
This display appears on the receiver.
3 Looking at the display on your
receiver, use the MULTI JOG to
select FUNCTION RENAME. Press
the ENTER button.
4 Use the MULTI JOG to select the
name of the function (for
example, DVD/LD) you want to
change. Press ENTER.
Either the cursor underline bar or a character
(depending on which is selected) will blink.
The functions are divided into three different on-
screen displays so you may have to move through
them to find the function you want to rename.
92
3-9 2
RETURN button
5 Use the MULTI JOG to cycle the
cursor through the letters,
numbers and symbols. Use the
ENTER button to enter one of the
possibilities or move forward a
space.
The possible selections are shown below.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!"#$%&'()*+,–./:;<=>?@[ \ ]ˆ_{|} [space]
6 Repeat step 5 until you get the
name as you want it.
You can input up to ten characters.
7 Press ENTER repeatedly to exit
the name. The new function
name is set.
8 Repeat steps 4-7 to change other
function names. Use the MULTI
JOG to select EXIT and press
ENTER.
9 Use the MULTI JOG to select EXIT
and press ENTER.
This exits the SYSTEM SETUP mode and returns to
normal operation.
Memo:
Use the RETURN button to move the cursor back one
character when entering a name.