Philips Norelco G290 User Manual page 10

Trimming Nose Hair
◗
Make sure nasal passages are clean.
1 Place nose, ear and eyebrow attachment on
Groomer.
2 Switch the Groomer on and insert the tip of
the attachment into one nostil (fig. 14).
CAUTION: Do Not insert the tip more
than 3/16 in./5mm into your nostril.
3 Slowly move the tip in and out while turning
it around at the same time in order to
remove unwanted hair. For best results, make
sure the side of the tip is firm against skin.
This will reduce the tickling effect that can
occur during trimming of nose hair.
4 Turn off Groomer. Wipe attachment clean
after each use.
Trimming Ear Hair
◗
Clean outer area of ear and ear canal. Make
sure it is free of wax.
◗
Nose, ear and eyebrow attachment should be
on the Groomer.
1 Switch the Groomer on and move the tip
softly around the edge of ear to remove
hairs extending beyond the outer ear (fig. 15).
2 Carefully insert the tip into outer ear canal.
CAUTION: Do not insert the tip further
than 3/16 in./5mm into the ear as this
could cause damage to the eardrum
(fig. 16).
3 Turn off Groomer. Wipe attachment clean
after each use.
Trimming Eyebrow
◗
Nose, ear and eyebrow attachment should be
on Groomer.
1 Switch the Groomer on and use the tip to
cut individual eyebrow hairs.
The Groomer can be used for clipping single long
hairs.
2 Put the Groomer at the root of the hair and
move it along the edge of the eyebrow from
the base of the nose towards the outer tip
of the eyebrow in the direction of hair
growth (fig. 17).
IMPORTANT: Do not use the Groomer to define
or trim the entire eyebrow. Do not try to trim
your eyelashes. Be careful not to get too close to
your eyelashes and eyes!
3 Turn off Groomer. Wipe attachment clean
after each use.