Panasonic Toughbook CF-U1GQG6L2M Reference Manual page 84

Wireless LAN
Enabling/Disabling the Wireless LAN Standard IEEE802.11a (802.11a)
When using wireless LAN outdoors or in a location where use of IEEE802.11a is prohibited, perform the following steps to
disable IEEE802.11a (administrator password required).
If you do not know the administrator password, disable wireless LAN (
1
Click on the notification area and click
2
Click [802.11a Enabled] or [802.11a Disabled].
A standard user needs to enter an administrator password.
NOTE
In some countries, communication using IEEE802.11a (5 GHz wireless LAN) standard is restricted by law.
The Wireless Switch Utility icon (
less WAN, not the setting of IEEE802.11a.
If IEEE802.11a is enabled or disabled while the computer is connected to an IEEE802.11b/g access point, the connec-
tion will be temporarily interrupted.
You can also change the IEEE802.11a setting in [Device Manager].
Click (Start) - [Computer] - [System properties] - [Device Manager].
A
A standard user needs to enter an administrator password.
Double-click [Network adapters] and double-click [Intel(R) WiFi Link 5100 AGN].
B
Click [Advanced], and then select [Wireless Mode] in [Property].
C
Select the settings in [Value] (e.g., [5. 802.11a/g]).
D
Click [OK].
E
If you enable or disable 802.11a using the pop-up menu of Wireless Switch Utility, the setting in [Device Manager] will
be accordingly changed as below.
Settings in Device Manager
[6. 802.11a/b/g]
[4. 802.11b/g]
[3. 802.11g]
[5. 802.11a/g]
[1. 802.11a]
[2. 802.11b]
or ) indicates the on/off status of wireless LAN and/or Bluetooth and/or wire-
Settings in Wireless Switch Utility
When 802.11a is enabled
a+b+g is enabled
a+g is enabled
a is enabled
page 82).
or .
When 802.11a is disabled
b+g is enabled
g is enabled
b is enabled
84