Setting The Wireless Lan Access Point - Panasonic Toughbook CF-19PJRFXAM Reference Manual

Wireless LAN
Right-click [Wireless Network Connection] and click [Enable].
C
• A standard user needs to enter an administrator password.
• When [Disable] is displayed, [Wireless Network Connection] is already enabled.
Turn on wireless LAN in the Wireless Switch Utility.
D
NOTE
You can use the following procedure instead of turning on wireless LAN in the Wireless Switch Utility.
Click (Start) - [Control Panel] - [Adjust commonly used mobility settings].
A
Click [Turn wireless on] in [Wireless Network].
B
• When [Turn wireless off] is displayed, the wireless network is already on.
• If you cannot select [Turn wireless on], the wireless switch is turned off.

Setting the wireless LAN access point

Preparation
Follow the instruction manual of the wireless LAN access point to make settings for the access point to recognize the com-
puter.
1
Turn the wireless LAN on.
2
Click or
If your computer is already connected to another network, click [Connect / Disconnect]. The [Connect to a network]
screen appears.
3
Click and select an access point, and click [Connect].
4
Input the key you set for the access point to recognize the computer, and click [Connect].
Wait for the computer to connect to the wireless LAN access point.
When [Successfully connected to XXXX] is displayed, the wireless LAN setting is complete.
[Save this network] : Add a check mark to save the password, settings, etc.
[Start this connection automatically] : Add a check mark so the computer automatically detects the access point
and connects to the Internet.
5
Click [Close].
NOTE
The settings depend on the network environment. For further information, ask the system administrator or the person
in charge of the network.
on the notification area and click [Connect to a network].
85