Connecting The Supplied Power Cable - NEC NP1200 User Manual

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cable in the wall outlet.
To wall outlet ←
About Direct Power Off
The projector has a feature called "Direct Power Off". This feature allows the projector to be turned off (even when
projecting an image) using the Main Power Switch or disconnecting the AC power supply.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting
to display an image.
CAUTION:
Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated
while the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so can
cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.
NOTE: To turn off the AC power supply when the projector is powered on, use the Main Power Switch or a power strip equipped
with a switch and a breaker.
Make sure that the prongs are fully inserted into both
the AC IN and the wall outlet.
20
2. Installation and Connections