Turning Off The Projector; After Use - NEC NP1200 User Manual

7 Turning off the Projector

To turn off the projector:
1. Press the POWER (ON/STAND BY) button on the projector cabi-
net or the POWER OFF button on the remote control.
The [POWER OFF / ARE YOU SURE? / CARBON SAVINGS- SES-
SION 0.000[g-CO2]] message will appear.
2. Press the ENTER button or press the POWER(ON/STAND BY) or
the POWER OFF button again.
The lamp will turn off and the projector will go into standby mode.
When in standby mode, the POWER indicator will light orange and
the STATUS indicator will light green when [NORMAL] is selected for
[STANDBY MODE]. Immediately after turning on the projector and
displaying an image, you cannot turn off the projector for 60 sec-
onds.
3. Turn off the Main Power Switch.
The power indicator will go out.
About Direct Power Off
The projector has a feature called "Direct Power Off". This feature
allows the projector to be turned off (even when projecting an im-
age) using the Main Power Switch or disconnecting the AC power
supply.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes
immediately after turning on the projector and starting to display an image.
CAUTION
• Do not unplug the power cable from the wall outlet or projector
when the projector is powered on. Doing so can cause damage
to the AC IN connector of the projector and (or) the prong plug of
the power cable. To turn off the AC power supply when the projec-
tor is powered on, use the Main Power Switch.
• Do not turn off the AC power supply within 10 seconds of making
adjustment or setting changes and closing the menu.
Doing so can cause loss of adjustments and settings and return
to default.

8 After Use

Preparation: Make sure that the main power is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
4. Cover the lens with the lens cap.
3. Projecting an Image (Basic Operation)
31