Indicators - Mitsubishi Electric WL2650U User Manual

Mitsubishi wl2650u: user guide
Hide thumbs Also See for WL2650U:
Table of Contents

Advertisement

Indicators

This projector has 2 indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problems persist, turn the projector off and consult your
dealer.
Normal condition
S TA TUS
POWER
Steady
Off
red
Blinking
Steady
green
green
Steady
Steady
green
r
green
Abnormal condition
POWER
S TA TUS
Steady
g r een
or
Blinking orange
Steady r ed
Steady r ed
Blinking g r een
Steady
Blinking g r een/ r ed
g r een
Blinking r ed
Steady r ed
Steady r ed
Steady r ed
O f f
Blinking
g r een/ r ed
Steady
or
Blinking
g r een/ r ed
Blinking
*1: Duration when LAMP MODE of the INSTALLATION menu is set to LOW. When it is set to STANDARD, this duration will be
shorted.
*2: When LAMP MODE is set to STANDARD, this duration will be shorted up to 2000 hours.
CONDITION
Stand-by
Lamp stand-by for power-on (about 1 minute)
Lamp stand-by for power-off (about 2 minutes)
The power is on. (Normal condition)
CONDITION
Abnormal temperatu r e
• The ventilation grilles a r e clogged with dust or dirt.
• The r oom temperatu r e is high.
The p r otection ci r cuit is working or the lamp is in an
abnormal condition.
Lamp operation time warning. (Total lamp operation time
reached 3000 hours
*1
while the power was on.)
Lamp operation time warning. (Total lamp operation time
*1
reached 3000 hours
while the power was off.)
Lamp operation time warning. (Total lamp operation time
*1*2
reached 4000 hours
while the power was off.)
The lamp cover isn ' t closed.
Abnormal.
POWER indicator
STATUS indicator
EN-37
NOTE
The power cannot be turned off by pressing
the POWER button.
For the first one minute, the power cannot be
turned on by pressing the POWER button.
POSSIBLE SOLUTION
• Clean the ventilation grilles.
• Relocate the p r ojector to a cooler place.
• W ait until the S TA TUS indicator goes out,
then p r ess the POWER button.
• If the above solution is not e f fective,
replace the lamp.
Replace the lamp.
Change with a new lamp if this p r oblem
r ecurs.
Close the cover cor r ectl y .
Contact your deale r .

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wl2650

Table of Contents