Indicators - Mitsubishi Electric WL7050 User Manual

Indicators

This projector has 3 indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problems persist, turn the projector off and consult your
dealer.
 Normal condition
POWER STATUS FILTER CONDITION
Off
Steady red
Blinking green
Blinking green
Steady green
Steady green
 Replacement
POWER STATUS FILTER CONDITION
Blinking green/
Steady green
red
Blinking red
Steady red
Steady red
 Abnormal condition
POWER STATUS FILTER CONDITION
Off
Blinking green/
Steady *4
red
or
Blinking *4
Steady red
or
Blinking orange
Steady green
Steady red Blinking green
*1: Duration when LAMP MODE of the INSTALLATION menu is set to LOW. When it is set to STANDARD, this duration will be shorted.
*2: Duration when LAMP MODE of the INSTALLATION menu is set to LOW. When it is set to STANDARD, this duration will be shorted
up to 3000 hours.
*3: When you press the POWER button on the projector or the remote controller, the STATUS indicator blinks red three times and
then resumes red illumination. During such a case, the power of the projector isn't turned on.
*4: Status of either or both of the indicators.
FILTER indicator
Power standby
Off
Cooling mode
Off
Lamp warmup mode
Off
The power is on. (Normal condition)
Off
Lamp operation time warning. (Total lamp operation
time reached 3000 hours
Off
Lamp operation time warning. (Total lamp operation
time reached 3000 hours
Off
Lamp operation time warning. (Total lamp operation
time reached 4000 hours
Off
Off
Abnormal
Abnormal temperature
The ventilation grilles are clogged with dust or dirt.
Off
a heating appliance.
The lamp is in an abnormal condition.
Off
POWER indicator
STATUS indicator
*1
while the power was on.)
*1
while the power was off.)
*2 .) *3
EN-62
NOTE
The power cannot be turned on by
pressing the power button.
The power cannot be turned off by
pressing the power button.
POSSIBLE SOLUTION
Replace the light source lamp.
Contact your dealer.
POSSIBLE SOLUTION
Unplug the power cord from the wall
outlet and contact your dealer.
place.
stop blinking green and then press
the POWER button.
not light up after carrying out the
above procedure several times,
replace the light source lamp.