Set Supervisor/User Password - MSI Crystal 945 User Manual

M S-6422
Set Supervisor / User Password
W hen you select this function, a message as below will appear on the screen:
Type the password, up to 8 characters in length, and press <Enter>. The
password typed now will replace any previously set password from CMOS memory.
You will be prompted to confirm the password. Retype the password and press
<Enter>. You may also press <Esc> to abort the selection and not enter a password.
To clear a set password, just press <Enter> when you are prompted to enter the
password. A message will show up confirming the password will be disabled. Once
the password is disabled, the system will boot and you can enter Setup without
entering any password.
W hen a password has been set, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any part of
your system configuration.
Important
About Supervisor Password & User Password:
Supervisor password can enter and change the settings of the setup menu.
User password can only enter but do not have the right to change the
settings of the setup menu.
3-22