Vcr Setup - LG 32LC2D Owner's Manual

Installation
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides
of the screen may remain visible on the screen.
When connecting with an antenna
ANTENNA ANTENNA
IN
CABLE CABLE
IN
ANTENNA
IN
CABLE
IN
When connecting with a RCA cable
VCR
OUT
(R) AUDIO (L) VIDEO
IN
AV OUT
1
(
VIDEO AUDIO
AV IN 1
AV OUT V OUT
( )
MONO
VIDEO AUDIO
AV IN 1 V IN 1
• If you have a mono VCR, connect the audio cable from the VCR to the AUDIO L/MONO jack of the
set.
• This TV finds the connected input sources automatically for AV1, AV2 and Component 1-2. It is pre-
sumed that RGB and HDMI/DVI sources are connected.
AV OUT
22
(
VIDEO AUDIO
AV IN 1
AV OUT
( )
VIDEO AUDIO
2
ANT IN
S-VIDEO OUT
ANT OUT
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4
IN
1
ANT IN
S-VIDEO ANT OUT
OUTPUT
SWITCH
3 4
)
S-VIDEO
VIDEO AUDIO
COMPONENT IN
S-VIDEO VIDEO AUDIO
COMPONENT IN
)
S-VIDEO VIDEO AUDIO
COMPONENT IN
S-VIDEO
VIDEO AUDIO

VCR Setup

Connect the RF antenna out socket of the VCR to
1
VCR
the Antenna socket on the set.
Connect the antenna cable to the RF antenna in
2
socket of the VCR.
Set VCR output switch to 3 or 4 and then tune TV
3
to the same channel number.
Insert a video tape into the VCR and press PLAY
4
on the VCR. (Refer to the VCR owner's manual.)
Connect the AUDIO/VIDEO jacks between TV
1
and VCR. Match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red)
Insert a video tape into the VCR and press PLAY
2
on the VCR. (Refer to the VCR owner's manual.)
3 Select AV1 input source using the INPUT button
on the remote control.
- If connected to AV IN2, select AV2 input source.