Sound; Custom Audic) Adjustment - Aiwa AV-D30 Operating Instructions Manual

CUSTOM AUDIO ADJUSTMENT"
MU+NG BALANCE
VOLUME CONTROL
Turn the VOLUME control on the unit, or press the VOLUME
buttons on the remote control.
The volume level is shown on the display for four seconds. It
can be adjusted between O and MAX (31). It flashes when being
set over thp level 21.
The volume level remains -memorized even after the power is
turned off. However, if the power is turned off when the volume
is set to more than 17, it is automatically set to 16 the next time
the power is turned on.
To adjust the Ieft/right balance of the front speakers
Press the BALANCE button to display "L/R OdB. Then press
the DOWNV or UPA button repeatedly within four seconds.
~
Note that the front speakers balance of the 5.1 CH and Dolby
~'
Pro Logic modes is also changed.
t
,.
To mute the sound temporarily
Press the MUTING button (-20 dB).
"MUTE ON" appears on the display for four seconds. While
muting the sound, the selected function indicator flashes. Press
the MUTING button again to restore the sound.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
m'
Low-frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low-frequency sound is
originally emphasized. In this case, cancel the T-BASS system.
SOUND ADJUSTMENT DURING
RECORDING
The output volume and tone of the speakers or headphones .
may be freely varied without affecting the level of the recording.
/-
,'