JVC MP-XV841 Instructions Manual page 16

16
EN
SETTING UP
When you first use your-Mobile PC, always plug the AC power cord into the DC Input connector.
First, install the lithium-ion battery pack in the PC by following the steps below. Proceed with
the setup while the battery pack is charging. To avoid data loss due to power failure or any other
cause, check the points for battery recharging in Page 18.
1. Mounting/Dismounting the Lithium-Ion Battery Pack
• Mounting Battery Pack
1 Slide lock lever A in the direction of the arrow
( ).
2 Mount and lock the battery pack until it clicks.
3 Slide lock lever A in the direction of the arrow
( ).
2. Open the display panel
1 Slightly pull up the buckle of the Note PC,
and the display panel will be unlocked.
Lock lever A
Buckle
• Dismounting Battery Pack
Lock lever B
1 Slide lock lever A in the direction of the arrow
( ).
2 Slide and hold lock lever B in the direction of
the arrow ( ), and pull out and dismount the
battery pack in direction 3 as shown.
2 Carefully open the display panel to the desired
angle. You can open the display panel to 180
degrees.
SETTING UP