I Slow Data Communication - Icom IC-2200H Instruction Manual

I Slow data communication

In addition to the digital voice communication, a slow data
communication is available (Refer p. 5 about the transceiver-
PC connection details).
q Set the desired frequency.
wSet another settings, such as repeater call, digital code
squelch, transmit output power.
e Push [BANK
] for 1 sec. then push [BANK
OPT
[V/MHz] several times to select the automatic data trans-
mission setting. (see p. 69)
• "ATX" appears.
• Skip this setting, if you want to transmit manually.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
r Push [BANK
OPT ] once to select the data communica-
tion speed setting. (see p. 70)
• "SPD" appears.
• Select suitable data speed for your PC or application.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
] or
OPT
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
DIGITAL MODE OPERATION
t Start up the slow data communication application.
ySet the application as follows.
• Port : The same COM port number as IC-2200H's
: 4800 bps or 9600 bps (same as step r)
• Baud rate
• Data : 8 bit
• Parity : None
• Stop : 1 bit
• Flow control : Xon/Xoff
uTransceiver automatically transmits or receive the data
when you sending data to transceiver. Or push and hold
[PTT] to transmit, release to receive the data manually.
• Refer to the instruction of the application that how to send or re-
ceive data.
z Set the desired frequency.
BANK/OPTION x Set another settings, such as repeater, dig-
ital code squelch, transmit output power.
c Push [BANK/OPTION] for 1 sec. then
push [BANK/OPTION] or [MR/CALL] to
select the automatic transmission setting.
• "ATX" appears.
• Skip this setting, if you want to transmit manually.
v Push [BANK/OPTION] to select the data
communication speed.
• "SPD" appears.
• Select suitable data speed for your PC or ap-
plication.
b Start up the slow data communication ap-
plication, then follow step y at above.
12
12
68