Hitachi UltraVision L42S503 Operating Manual page 8

How To Install Your New Hitachi LCD Television
WALL MOUNTING SETUP
STEP (1) : REMOVE THE STAND BASE FROM THE LCD TELEVISION
In order to remove the stand from the TV, please put the TV set on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any
damage; then remove the 4 screws shown below in order to separate the TV from the Table Top Stand. Now the Stand can be separated
from the TV. Useful dimensions for the WALL MOUNT assembly are in page 45.
STEP (2) : INSTALL THE WALL MOUNT BRACKETS ON THE LCD TELEVISION USING 4 SCREWS.
For Wall Mount assembly; please refer to the Installation Manual of the
Wall Mount Unit.
CAUTION
STEP (3) : TIPS TO CONSIDER FOR THE LOCATION OF THE LCD TELEVISION.
More than
30 cm (1').
More than
10 cm (4").
CAUTION
installation of this LCD Display Panel using wall mounting brackets/devices be performed only by a qualified and experienced television
installation technician who has completed a thorough evaluation of:
a) the weight-bearing strength and stability of the intended wall mount surface; and
b) the weight-bearing strength and compatibility of the intended wall mount brackets/device.
8
Screw Mounting Holes (4 locations). Don't
use the original screws (A) that were
in the TV for the Table Top Stand. The
original screws are not long enough to
properly secure the TV to the wall bracket.
Wall Mount Brackets
Insertion length (B) of the screws must be within 8.5~10.5 mm. If the length is less than 8.5
mm, the weight can not be maintained. If the length is more than 10.5 mm, a space is created
between the Wall Mount Bracket and the LCD Television. This length is very important.
Keep
more than
2 cm (0.8")
away from
the wall.
Although this LCD Display Panel can be installed using a variety of third party wall mounting brackets/devices,
such third party brackets/devices have not been tested or approved by Hitachi for use or compatibility with
this LCD Display Panel. Accordingly, Hitachi accepts no responsibility or liability for any injuries or property
damage resulting from the use of such third party brackets/devices. Hitachi strongly advises that any
4 Screws M4.
CAUTION
• If you purchased a Wall Mount bracket, please ask for a professional
installation. Do not install by yourself.
• This LCD unit features an advanced ventilation system configured for
vertical installation. A knowledgeable and experienced professional
technician can perform other mounting or installation orientations (e.g.,
horizontal, tilted) provided that you specifically inform the technician of
the unit's specialized ventilation needs. Call 800-HITACHI for additional
info and guidance.
Stand Base
Screw Length (A)
Insertion length (B)
Spring Washer (C)
Plane Washer (D)
Wall Mount Bracket (E)
Example :
A = B+C+D+E
A: 13.5~15.5 mm.
B: 8.5~10.5 mm.
C: 1 mm.
D: 1 mm.
E: 3 mm.
The screw type :Thread ISO M6 (Metric
type, do not use Standard type).
• Do not block the ventilation holes. In
addition please keep a certain distance around and
make sure not to obstruct ventilation. Blocking the
ventilation holes might cause fire or defect.