Harman Kardon AVR 7200 Service Manual page 16

AVR7200
harman/kardon
INSTALLATION AND CONNECTIONS
AC Power Connections
This unit is equipped with three accessory AC outlets.
They may be used to power accessory devices, but
they should not be used with high-current draw equip-
ment such as power amplifiers. The total power draw
to each outlet may not exceed 100 watts.
The Switched AC Accessory Outlets a will receive
power only when the unit is on. This is recommended
for devices that have no power switch or a mechanical
power switch that may be left in the "ON" position.
NOTE: Many audio and video products go into a
Standby mode when they are used with switched out-
lets, and cannot be fully turned on using the outlet
alone without a remote control command.
The Unswitched AC Accessory Outlet · will
receive power as long as the unit is plugged into a
powered AC outlet.
The AVR 7200 features a removable power cord that
allows wires to be run to a complex installation so that
the unit itself need not be installed until it is ready for
connection. When all connections described above
have been made, connect the AC Power cord to the
AC Power Cord Jack °.
The AVR 7200 draws significantly more current than
other household devices such as computers that use
removable power cords. For that reason, it is important
that only the cord supplied with the unit (or a direct
replacement of identical capacity) be used.
Once the power cord is connected, you are almost
ready to enjoy the AVR 7200's incredible power
and fidelity!
16
16
INSTALLATION AND CONNECTIONS