Replace The Printheads - HP 610 Reference Manual

hp digital copier series
replace the
printheads
38
5
If there is plastic tape on the failed printhead, remove the plastic tape.
6
Push the failed printhead firmly down into the appropriate slot using
the printhead handle. Do not touch the printhead tower, and do not
remove the printhead handle.
7
Move the print carriage latch down, and make sure the loops catch
the hooks. Snap the latch into place, then close the print carriage
access door.
8
If the error message still appears, remove and reinsert the printhead
again and close the print carriage access drawer.
9
If the error message still appears, replace the printhead as described
in the following section.
If you experience problems with that quality of your copies that cannot be
resolved by cleaning your printheads, you may need to replace them. You
may also see front-panel display messages that indicate when an individual
printhead needs to be replaced.
See order printheads and ink cartridges on page 86 for information on
ordering replacement printheads.
1
Turn on the unit, then open the print-carriage access door by lifting
the handle until the door locks into place.
The print carriage moves to the center of the unit.
Pull the printhead handle upward
maintain your hp digital copier