HP Designjet 10000s User Manual page 7

III 4 4 Warnings
– Do not immerse the APS in water or other liquids.
– Do not use the APS in areas with very high concentration of dust.
– Do not use the APS outdoors.
– Use only the proper power cables supplied by HP with the APS.
– Use the power supply voltage specified on the nameplate. Doing otherwise may cause
fire or electric shock.
– Do not connect multiple loads to one power outlet. Doing so may cause fire or electric
shock.
– Do not disassemble or remodel the APS. Do not repair the APS by yourself. Doing so
may cause fire, electric shock, or other accidents.
– Do not remove the screwed covers, because they content high-voltage. Careless remo
val might result in electric shock or burn.
– See the label
– Do not disconnect or connect the power cable with wet hands. Doing so may lead to
electric shock.
– Turn the APS OFF and unplug he power cable from the power outlet if there is smoke
or an unusual smell coming from the APS.
– Do not install or operate the APS within 8 meters (25 feet) of open flames, sparks, or
other sources of ignition.
– Always use genuine HP replacement Filter Elements. These have been designed for reli
able filtration and qualified to work with your Designjet 8000s or 9000s/10000s prin-
ter. Using non-HP Filter Elements may result in ineffective filtration of volatile organic
compounds and pose health and safety hazards.
– Be sure all operators are trained in the use of emergency equipment such as eye wash
stations and fire extinguishers and know where they are located.
– Used filters capture an organic solvent (ethylene glycol monobutyl ether acetate,
CAS No. 112-07-2) and other chemicals from ink vapors. When disposing used filter
cartridges it is your responsibility to observe all local, state, and federal regulations rela
ted to the handling, use, storage, and disposal of organic solvents.
– Do not disassemble the filter elements.
– If any liquid is present on used filter elements, avoid contact with skin, eyes, and
clothing. Handle the used filters while wearing latex or Nitrile ® gloves. Immediately
wash skin that has come in contact with liquids with soapy water. Remove any clothing
soaked with liquids from contact with skin. If liquid comes in contact with eyes, use an
approved eye wash station and consult a doctor if necessary. If an approved eye wash
station is not available, flush eyes with cold water and contact a doctor if necessary.
– The liquid captured by the filters is combustible. Do not use or store used filters within 8
meters (25 feet) of open flames, sparks, or other sources of ignition.
– Do not smoke within 8 meters (25 feet) of the APS.
– Keep used filter cartridges out of the reach of children.
– Do not obstruct air inlets and outlet.
HP Air Purifier System
on the fan & electronics cover (Number 6 in APS description).
7