Table of Contents
Advertisement
7.
Remove the motor mount hex bolts shown in
Figure 80.
Hex Bolts
Figure 80. Motor mount hex bolts.
8.
With assistance, remove the motor and lower
it to the floor.
9.
Remove the three upper bearing cap screws
(see Figure 81), and thread them into the
alternate three holes to draw the bearing
housing up.
Alternate Hole
Figure 81. Upper bearing housing and cap
screws.
Note: Carefully pry up on the upper bearing
housing, rotate it, and repeat this process
until the housing comes free from the mill.
-54-
Cap Screw
10. Remove the two Phillips head screws that are
directly below the upper spindle bearing (see
Figure 82).
Phillips Head Screws
Figure 82. Upper spindle bearing.
11. Remove the lower cap screws holding the
variable speed housing onto the front of the
transmission case.
12. Remove the four cap screws shown in
Figure 83, then remove the cap screw from
the underside end of the transmission case.
Cap Screws
Figure 83. Upper transmission case cap screws.
Model G9901/G9902/G9903 Milling Machine
Advertisement
Table of Contents
